DFI PR610-C621 User Manual page 35

Atx industrial motherboard
Hide thumbs Also See for PR610-C621:
Table of Contents

Advertisement

Advanced
H2O IPMI Configuration
X
X
X BMC Configuration
Configure the BMC related settings in this sub-menu.
InsydeH2O Setup Utility
Advanced
BMC Configuration
Watchdog Timer Support
<Enabled>
Not disable in OS
<Enabled>
Watchdog Timer Timeout
[5]
Watchdog Timer Action
<Hard Reset>
►User Configuration
LAN Channel Number
[1]
IPv4 Source
<Static>
IPv4 IP Address
192.168.0.100
IPv4 Subnet Mask
255.255.0.0
IPv4 Gateway Address
0.0.0.0
IPv6 Mode
<Enabled>
IPv6 Prefix Length
[64]
IPv6 Static IP Address
0:0:0:0:0:0:0:0
IPv6 Gateway Address
0:0:0:0:0:0:0:0
F1
Help
↑ /↓
Select Item
Esc
Exit
←/→
Select Item
Wathcdog Timer Support
Enable or disable the BMC's Watchdog Timer (WDT) function at the start of POST. The follow-
ing fields will be configurable when this field is enabled.
Not disable in OS
Keep WDT enabled when boot in OS.
Watchdog Timer Timeout
Enter the number of minutes the system firmware has to boot the OS before it takes the Time-
out Action. Valid values are from 2 to 8 minutes.
Watchdog Timer Action
Select which timeout action shall be carried out when the WDT is up — No Action, Hard Reset,
Power Down, or Power Cycle.
LAN Channel Number
BMC's LAN channel number. There are three channels available — channel number from 1 to 3.
To configure a LAN channel, insert a channel number, and the IP settings of the selected chan-
nel will be listed in the following.
User's Manual | PR610-C621
Rev. 5.0
E n a b l e / D i s a b l e I P M I S u p p o r t .
Note: If changing to enable, BMC
detailed information only valid
after rebooting.
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
X
IPv4 Source
Select how BMC IPv4 settings are configured: automatically (DHCP) or manually (Static).
IPv4 IP Address
Enter the BMC IPv4 IP address. This field is only required when using Static IP.
IPv4 Subnet Mask
Enter the BMC IPv4 Subnet Mask. This field is only required when using Static IP.
IPv4 Gateway Address
Enter the BMC IPv4 Gateway Address. This field is only required when using Static IP.
IPv6 Mode
Enable or disable Internet Protocol v6 (IPv6).
IPv6 Prefix Length
Set IPv6 prefix length.
IPv6 Static IP Address
Enter the BMC IPv6 IP Address.
IPv6 Gateway Address
Enter the BMC IPv6 Gateway Address.
Chapter 3
BIOS SETTINGS
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sem2500Sem2510

Table of Contents