Install The Left And Right Steering Hoses; Install The Pressure Hoses - Raven SmarTrax Installation Manual

Chapter 3

Install the Left and Right Steering Hoses

Left and Right Steering Hose Connections
FIGURE 4.
Left Steer
Disconnect the left steering hose from the left steering cylinder.
1.
Install a -6 JIC M/M/F swivel run tee adapter fitting (P/N 333-0012-043) in the open left cylinder port.
2.
Connect the machine's left steering hose to the opposite end of the installed tee fitting.
3.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-901) on the 90° end of the installed tee
4.
fitting.
Note:
It may be necessary to install a -6 JIC M/F 90° swivel elbow fitting (P/N 333-0012-042) on the
installed tee fitting to achieve the connection.
Connect the 90° end of the installed hydraulic hose to the fitting installed in Port A of the SmarTrax valve.
5.
Disconnect the right steering hose from the right steering cylinder.
6.
Install a -6 JIC M/M/F swivel run tee adapter fitting (P/N 333-0012-043) in the open right cylinder port.
7.
Connect the machine's right steering hose to the opposite end of the installed tee fitting.
8.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-901) on the 90° end of the installed tee
9.
fitting.
Note:
It may be necessary to install a -6 JIC M/F 90° swivel elbow fitting (P/N 333-0012-042) on the
installed tee fitting to achieve the connection.
Connect the 90° end of the installed hydraulic hose to the fitting installed in Port B of the SmarTrax valve.
10.

Install the Pressure Hoses

Locate the machine's steering pump on the lower left side of the engine at the back of the air compressor.
1.
12 Miller Atlas 3654 SmarTrax™ Installation Manual
Right Steer