Updates; Preparing For Installation - Raven SmarTrax Installation Manual

Chapter 2

Updates

Updates for Raven manuals as well as software updates for Raven consoles are available at the Applied
Technology Division web site:
http://www.ravenprecision.com/Support/index2.jsp
Sign up for e-mail alerts and we will notify you when updates for your Raven products are available on the
Raven web site.
http://www.ravenprecision.com

Preparing for Installation

Before installing SmarTrax, park the machine where the ground is level, clean, and dry. Be sure to follow
proper safety practices and procedures during the SmarTrax installation procedure. Bleed pressure from the
hydraulic system and leave the machine turned off for the duration of the installation process. Carefully read
and follow the instructions in this manual to properly complete the installation process.
Recommendations
Observe the following recommendations while installing the SmarTrax system:
•
Use part numbers to identify parts.
•
Do not remove the plastic wrapping from a part until it is necessary for installation.
•
Do not remove plastic caps from a part until it is necessary for installation.
Tools Needed
Before beginning the installation process, it is a good idea to gather all the tools that you will need. These tools
include the following items:
•
Screwdrivers of various sizes
•
SAE Standard-sized wrenches
•
Allen wrenches
•
Utility knife
•
Drill
•
Drill bits
•
Side Cutters
•
Pliers
Point of Reference
The instructions in this manual assume that you are standing behind the machine, looking toward the cab.
4 Buhler/Versatile 4WD 305 - 400 & HHT 4WD 400 - 575 SmarTrax Installation Manual