Raven SmarTrax Installation Manual page 28

Chapter 5
Connect your receiver or source of DGPS to the connector labeled 'DGPS' on the node adapter cable.
7.
Connect the console providing machine guidance to the remaining small, round connector.
8.
Connect the 4-pin deutsch plug to the vehicle's CANbus system (Viper Pro/Envizio Pro) or the DB-9 display
9.
cable (Cruizer).
Electrical hookup is recommended as shown in the Can Node Wiring Diagram on page 30.
10.
Note:
High Current Power, which is used to run steering operations, should be connected to a separate
power source than Logic Power, which is used to run processing and communication between the
node and the guidance console.
Power and Ground
FIGURE 6.
24 Buhler/Versatile 4WD 305 - 400 & HHT 4WD 400 - 575 SmarTrax Installation Manual
Power
Ground Buss Bar Located On Lower Right Rear Cab Post