Installation And Setting Up; Checking For Damage; Positioning - Silca Quattrocode Operating Manual

Operating manual - English
3

INSTALLATION AND SETTING UP

Installation can be carried out by the purchaser and does not require any special skills.
The key-cutting machine is supplied ready for use and assembly is not necessary. However, some
checks and preparation for use need to be carried out.
Environmental conditions
To ensure that the best use is made of the key-cutting machine, certain parameters must be borne
in mind: damp, badly ventilated sites should be avoided. The ideal conditions for the machine are:
temperature between 0 and 40°C, relative humidity approx. 60%.
3.1

Checking for damage

The Quattrocode is solid and will not normally damage if transport, unpacking and installation have
all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
3.2

Positioning

• Place the machine on a horizontal surface, solid enough to take the weight (60 kg). The
workbench should ideally be at a height of approx. 100 cm, which ensures easy access to the
working parts. Leave at least 30 cm clearance behind the machine to provide ventilation and
30 cm on both sides.
• Connect the power supply cable and the serial cable to their sockets.
WARNING: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Rear view
Fig. 8
14
Switch
Copyright Silca 1999
100 cm.
QUATTROCODE