Volvo Penta TAD1630G Workshop Manual page 91

Group 22
9
Place the gear wheels in the pump housing.
10
Fit the pump housing to the bracket.
Note: Check that the gears turn easily.
11
Heat up the pump drive to 180°±20°C (356° ± 36°F). Tap the
drive gear on to the pump shaft. The drive can also be
pressed in using drift 999 6413 using 999 8012 as an anvil.
The illustration numbers above refer to the relevant point in the text below.
Service procedures - lubrication system
Note: The clearance between the drive gear and the
bracket should be 0.4-1.0 mm (0.0157-0.0394").
12
Fit the thrust washers, the hub, the idler gear and the bearing
end plate. Fit the flange screws.
89