Service Procedures; Lubricating Oil Pressure, Checking; Oil Filters, Replacing - Volvo Penta TAD1630G Workshop Manual

Service procedures - lubrication system
Lubricating oil pressure,
checking
Special tools: 999 6591, 999 6398
1
Lubrication oil pressure is checked by connecting the pres-
sure gauge and hose to the connection on the oil pressure
contact. With hot engine and at operating speed, the oil pres-
sure should be 300-500 kPa (43,5-72,5 psi). At engine idling
speed, the oil pressure should be min. 150 kPa (21.75 psi).
82

Service procedures

The engine must always be washed prior to starting repairs.

Oil filters, replacing

Special tools: 999 9179
1
Clean around the filter bracket and remove the 3 filters us-
ing tool 999 9179.
2
Moisten the seals of the new filters with oil and screw the fil-
ters on by hand until the seals are in contact with the filter
bracket. Then tighten the filters by hand a further half turn.
Note: Install only Volvo oil filters type "Long Life." The
oil filters must not be damaged. If the filter is dented, it
may crack, resulting in engine breakdown.
3
Fill the engine with oil. Crank the engine with the stop button
depressed or the stop control pulled out until oil pressure is
recorded by the pressure gauge.
Note: Cranking the engine with the stop control pulled out
applies when replacing filters and oil cooler or other compo-
nents of the lubricating oil system.
Start the engine and check for leaks around the oil filters.
Group 22