Volvo Penta TAD1630G Workshop Manual page 121

Group 22 Service procedures - intake and exhaust systems
18
Torque the compressor lock nut with a T-handle torque
wrench to 13.6 Nm (10 ft-lb) and then rotate to an additional
90°-95° and apply 2 drops of Loctite 601 to the threads.
Note: Use a T-handle torque wrench together with a univer-
sal joint to avoid side-loading the turbine wheel shaft.
19
Fit the bearing assembly into the compressor cover (3), align
with the marks, fit the V-clamp (10) and torque the locknut to
11 Nm (8 ft-lb).
20
Fit the bearing assembly into the turbine housing, align with
the marks, fit the V-clamp and torque the locknut to 11 Nm
(8 ft-lb).
119