Volvo Penta TAD1630G Workshop Manual page 137

Group 22
27
Continue to press in the shaft carefully until the outer race
of the ball bearing stops against the circlip in the pump
housing.
28
Replace the ball bearing set screws.
Note: Secure the screws with locking fluid (Part No.
1161053-0).
29
Turn the pump over in the hydraulic press to bring the
drive side facing down. Position the pump in the press so
Service procedures - cooling system
that the pump shaft is free and the walls of the pump shaft
take up the pressing force.
30
Mount the deflector ring onto the pump shaft with the edge
facing down.
31
Press on the deflector ring until tool 999 8000 bottoms
against the edge of the pump housing.
135