Volvo Penta TAD1630G Workshop Manual page 49

Group 21
11
Install the liner in the cylinder block aligning to the previ-
ously made marks. Use standard handle 999 2000 and
drift 999 6236. Press with care.
12
Fit the sealing ring between the block and the collar of the
liner. Use drift 999 6967.
13
Fit the clamping tool.
14
Oil the piston and put it into the liner with the marking (ar-
row) pointing forward.
15
Check that the bearing shells are a correct fit to the connect-
ing rod and caps. Screw down the caps according to the
markings, using a torque of 250 Nm (184.5 ft-lb).
16
Fit the piston cooling nozzle. Torque the nozzle nut to 25 Nm
(18.45 ft-lb).
17
Check the piston height beneath the face of the cylinder
block. Turn the engine, using tool 998 3590 until the pis-
ton is in T.D.C. (0° on the flywheel).
18
Correct piston height 0.9–1.5 mm (0.0355–0.0591").
Service procedures - engine
47