Volvo Penta TAD1630G Workshop Manual page 135

Group 22
17
Oil the pump shaft and press the inner race of the roller
bearing into position. Press until its stops.
18
Put the pump housing in the press. Oil the seat of the roller
bearing in the pump housing.
19
Oil the outer race of the roller bearing. Put the bearing
with the text facing upwards into the pump housing. Press
the bearing into position using tool 999 6998. Press until
its stops.
20
Turn the coolant pump over to bring the drive side facing
down in the press.
Service procedures - cooling system
21
Grease the edge of the seal. Put the seal into the pump
with the metal edge facing upwards.
22
Press in the seal with tool 999 8000. Press until the tool
bottoms against the edge of the pump housing.
133