Volvo Penta TAD1630G Workshop Manual page 34

Service procedures - engine
11
Fit the tappets, resting them against the camshaft.
Note: The tappets must be placed in an oil bath before fitting.
New tappets are packed in oil. The oil must not be removed
before fitting. Observe good cleanliness when handling the
tappets!
12
Fit the push rods.
Note: Make sure that the tappets and push rods are in their
correct positions.
13
Fit the rocker arm mechanism, torque 48 Nm (35.4 ft-lb).
14
Adjust the valves. See "Valves adjusting".
15
Fit the valve cover together with the gaskets.
16
Fit the coolant distribution pipes, and the thermostat housing.
32
17
Torque the exhaust manifold bolts to 48 Nm (35.4 ft-lb).
18
Fit new O-rings to the inlet pipes of all cylinders.
(On TWD1630, the delivery pipes to the injectors have to be
fitted before the inlet manifold.)
19
TAD1630P/V only
Connect the smoke limiter hose to the inlet pipe.
20
Connect the cables to the starter heater.
21
Remove all protective plugs from the injectors and the in-
jection pump.
22
Fit the delivery pipes and the fuel return pipe together with
washers, clamps and brackets.
23
Fit all other dismounted details (brackets filters etc.
24
Fill with coolant. Bleed the fuel system.
Group 21