Volvo Penta TAD1630G Workshop Manual page 63

Group 21
10
Crank the engine around until the tip of the dial indicator
is in its top position. Make a note of the dial indicator read-
ing. The lifting height must not be less than.
Min. inlet 7.80 mm (0.3073").
Min. exhaust 7.35 mm (0.2896").
11
Check the lifting height on all the other cams of the cam-
shaft in this same manner.
12
Remove the magnetic stand, the dial indicator and the
steel ball.
13
Fit the push rods in the order they were fitted previously.
14
Fit the rocker arm assemblies.
15
Adjust the valves, fit the valve covers.
16
Fit the delivery and fuel return pipes.
17
Remove tool 999 3590 from the flywheel casing, fit the
plug.
Service procedures - engine
61