Unpacking; Power Connection; Power Cords - Cablescan 90 Series Reference Manual

2.0 Setup Page I
UNPACKING
Components of the Series 90L4/90H4 are packaged in a foam-packed shipping carton. Carefully
unpack the components, and set the container aside for future use. Visually inspect each
component for damage or deficiency. Record any deficiencies and report them to Cablescan. In
the event the equipment has been damaged as a result of shipping, notify the carrier and
Cablescan immediately.
POWER CONNECTION
Before applying power to the Series 90L4/90H4, make sure that the operating voltage is correct
and the unit is properly grounded (see GROUNDING THE UNIT, below).
POWER CORDS
The power cord is supplied with North American type plugs. The plug ends must be replaced for
countries with another standard. To help make the change easier, the power cord wires are coded
with the International color code standard. A translation table for the North American and
International color code standards is provided below.
INTERNA TIONAL NORTH AMERICAN
COLOR CODE COLOR CODE
LINE brown white
NEUTRAL blue black
GROUND green/yellow green
SERIES 90L4/H4 CON'NECTION PROCEDURE
Arrange the Series 90L4/90H4 alongside the PC. Connect the power cords as shown in Figure 1,
and as described belm.v:
on rear
IS
connector on rear
3. Connect PC and tester serial ports with 9-conductor (9100069).
to