Series 90 System Setup; Unpacking; Power Connection; Grounding The Unit - Cablescan 90 Series Setup Manual

Page 6

UNPACKING

The major components of the Series 90 are packaged in foam-packed shipping cartons.
Carefully unpack the components, and set the containers aside for future use. Visually inspect
each component for damage or deficiency. Record any damage or deficiency and report it to
Cablescan. In the event the equipment has been damaged because of shipping, notify both the
carrier and Cablescan immediately.

POWER CONNECTION

Before applying power to the Series 90, make sure that the operating voltage is correct and the
unit is properly grounded (see GROUNDING THE UNIT, below).

Grounding the Unit

Each component of the Series 90/90HV is shipped with a three-wire (grounded) power cable.
When the cable is connected to a three-wire (grounded) power receptacle, it connects the chassis
of the unit to ground.
Continuity of the grounding circuit is vital for the safe operation
of the units. Never operate the Series 90 system through an
ungrounded power connector, or with the grounding conductors
disconnected.

Power Cords

All power cords are supplied with North American-type plugs. The plug ends must be replaced
for countries with other standards. To help make the change easier, the power cord wires are
coded with the International color code standard. A translation table for the North American and
International color code standards is provided below.
LINE
NEUTRAL
GROUND

SERIES 90 SYSTEM SETUP

WARNING
INTERNATIONAL
COLOR CODE
brown
blue
green/yellow
Series 90 Setup Manual
NORTH AMERICAN
COLOR CODE
White
Black
Green