Table of Contents
Advertisement
•
•
•
2.0 Setup
Page 9
5. Pressing Y from the update display will copy all the files of Disk # 1 to the displayed
disk drive and directory. The following window will display by pressing N from the
Update display or pressing Y from the New Installation display:
PLEASE CHOOSE YOUR INSTALLATION DIRECTORY
(USE A FIXED DRIVE)
[C:\S90
6. The default location for the Series is C:\S90. If you want a different location, enter a
drive and directory.
7. After the correct drive has been entered, press ENTER; the following will display.
Each file name will display as it is copied to the disk location specified.
Installing files. Press a key to interrupt.
C:\S90$S90.OVL C:\S90\CNTR2.HEX
After all files on Disk # 1 have been copied to the hard drive, the following window
will display:
Please insert disk #2 into drive
A.
Press a key to continue.
8. Install Disk #2 and press ENTER.
9. After all files on Disk #2 have been copied to hard drive, the following window will
display if the installation is an update:
Communication Port Setup
Your current SYSTEM.DEF file specifies COM1: as the
communication port connected to the tester unit. This is used for
Series 90L4 and Series 90H4 testers.
Do you want to keep the current selection?
Press "Y" for Yes, UN" for No, or <Ctrl X> to quit.
Pressing Y from the above screen, or when installing the software for the first time.
displays the following window.
Advertisement
Chapters
Table of Contents
