Table of Contents
Advertisement
Page 4
2.0 Setup - Series 90i90HV
CHANGING POWER SETTING
The Series 90 is normally shipped with the proper power setting. The power supply in the
expansion chassis automatically adjusts to the input power source; however, the system
controller must be manually switched.
When a power setting change is required, see
Figure 2 and follow the instructions provided below:
1. Partially displace top cover of controller.
a.
Tilt unit on edge and remove four bottom screws.
b.
Remove five screws around outside edges of rear panel.
c.
Pull top cover forward about 4 inches.
2.
Locate voltage select switch (above ON/OFF switch on right side), and move slide to
desired setting (115 or 230).
3.
Replace cover and reinstall mounting screws removed in step 1.
L
220 VOLT POSITION
110 VOLT POSITION
Advertisement
Chapters
Table of Contents
