Table of Contents
Advertisement
•
•
•
2,0 Setup - Series 9019QHV
HARD DISK
SETUP
The Series 90 System Controller is supplied with a hard disk setup as shown below, The
contents of the
AUTOEXEC,BAT
and
CONFIG,SYS
files are documented below in case the Series 90
software is be run on a different computer, Since the Series 90 Install program replaces these
two files during installation, it may be preferred, as an alternative, to use the DOS copy
command to load the Series 90 software, and then edit your existing
AUTOEXEC,BAT
and
CONFIG,SYS
files,
Directory Structure
The
AUTOEXEC,BAT
and
CONFIG,SYS
files, as shown below, are set up to operate from the
following directory structure, If, however, the Series 90 software is installed in a different
directory, the
SET
commands in the
AUTOEXEC.BAT
file must change accordingly,
Root
Directory
C:\
I
t
I ------
OS
SERIES 90
AUTOEXEC.BAT File
ECHO OFF
VERIFY ON
:\
PROMPT $e[1;37;44m$t$h$h$h $p $q$q$g
SET COMSPEC=C:\DOS\COMMAND,COM
SET S90ROOT=C:\S90
SET S90PROG=C:\S90\PROG
SET S90DATA=C:\S90\DATA
SET S90TEMP=C:\S90\ TEMP
PA TH=C:\DOS;C:\S90
APPEND C:\DOS
MODE CON RA TE=32 DELA Y=3
IF NOT EXIST C:\S90\TEMP\*,* GOTO NoFiles
ECHO YIDEL C:\S90\TEMP\*, * >NUL
:NoFiles
CDC:\S90
SERIES90
CONFIG.SYS File
FILES =48
BUFFERS =24
STACKS =0,0
SHELL = C:\DOS\COMMAND,COM
1E:5121P IMSG
DEVICE = C:\DOS\ANSLSYS IL
DEVICE = C:\DOS\HIMEM,SYS
DEVICE = C:\DOS\SMARTDRV,SYS 512
DEVICE = C:\OVLDATA,SYS
C:\
Advertisement
Chapters
Table of Contents
