Cablescan 90 Series Reference Manual page 25

2.0 Setup - Series
90/90HV Page 19
4. Press ESC to cancel the DOS Install procedure. (Do not press ENTER.) The screen
will display an Exit message as shown below:
Enter Esc=Cancel
Exit
You have chosen to end SELECT.
If you are sure you want to end DOS installation,
press F3
If not, press Enter to continue installation.
5.
Press F3 to exit the DOS Install procedure. The DOS prompt( » will then appear.
6. Type ATSETUP and press ENTER. The screen will then display system
configuration setup information as shown below:
Phoenix Technologies Ltd.System
System Configuration Setup V4.0
Time: 10:58:36
Date: Thu Sep 06, 1990
Diskette A:
Diskette B:
Hard Disk C:
Hard Disk D:
Base Memory:
Extended Memorv:
Display: .
Keyboard:
CPU Speed:
Coprocessor:
3.5 Inch, 1.44 MB
Not Installed
(see below)
Not Installed
640 KB
(see below)
EGA/VGA
Installed
High
Not Installed
Up and Down Arrow to select entries
Left and Right .A.rrow to change entries
F1 to get help on current entry
Esc co reboot the system
7,
as to screen.
changed during production. See configuration table
correct hard disk and extended memory settings for the serial number of your system
controller. (The serial number is on a label located on the rear of
') 'n1E! St:t
to