Expansion Cabinets; Additional Expansion Cabinets; Controller And Expansion Cabinet Hookup - Cablescan 90 Series Reference Manual

2.0 Setup - Series
90/90HV
Page 7
EXPANSION CABINETS
The expansion cabinet is connected to the system controller through a 9-conductor cable (part
number 9100069). See Figure 5. This cable has a female 9-pin D connector on one end and a
male 9-pin D connector on the other.
1. Connect female end of cable to bottom connector of Expansion Input/Output Board
(Slot 1); connect male end to INPUT connector on the expansion cabinet.
2. VerifY that a terminating plug (part no. 5210974) is connected to OUTPUT
connector on expansion cabinet.
*
See below for adding more Expansion Cabinets.
Expansion Cabinet (Series 9DE9 shown)
Blue Terminating Plug
0.1
/
System Controller
Figure 5. Controller and Expansion Cabinet Hookup
ADDITIONAI-J EXPANSION CABINETS
the is to ,
and end is connected to the INPUT connector on second cabinet If the second
cabinet is the last the chain, connect the terminating plug to its OUTPUT connector. (The
AUU"'"""L,.,
plug is attached only to the expansion cabinet.)