Cablescan 90 Series Reference Manual page 30

Pal:e 24 2,0 Setup - Series 90/90HY
Closin2 EXPansion Cabinet
1, Install the three screws that hold the power receptacle bracket to the cabinet.
2. Replace the back panel and install the mounting screws, including the hex screws
securing the 9-pin connectors.
3. Insert the termination plug into the connector marked OUTPUT.
4. Reconnect the cable between System Controller and Expansion Cabinet.
5. Reconnect the power cables.
Final Test
1. Turn on the power switch and observe the red LED lamps on the boards. They
should light momentarily for approximately two seconds.
2. Reconnect test fixture interface cabling if all LEDs turn off.
•
•
•