Integra CODMAN CERTAS Plus Manual page 15

The essential performance of the electronic Locator device is to locate the
CERTAS Plus programmable valve mechanism and display an indication dial
for the determination of valve performance setting.
WARNING: Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used no closer than
30 cm (12 inches) to any part of the locator device. Otherwise, degradation of
the essential performance of this equipment could result, meaning the device
may not provide a stable indication or screen flickers may be seen.
WARNING: Use of this equipment adjacent to or stacked with other
equipment should be avoided because it could result in improper operation.
If such use is necessary, this device and the other equipment should be
observed to verify that they are operating normally.
Guidance and manufacturer's declaration
The CERTAS Plus Electronic Tool Kit is intended for use in the
electromagnetic environment specified below. The customer or the user
of the Tool Kit should ensure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
Table 1
- electromagnetic emissions
Compliance
Group 1
Class A
Not
Applicable
Not
Applicable
14
Electromagnetic
environment – guidance
The Locator uses RF energy only for
its internal function. Therefore, its
RF emissions are very low and are
not likely to cause any interference
in nearby electronic equipment.
The Locator is suitable for use in all
establishments other than domestic
and those directly connected to the
public low-voltage power supply
network that supplies buildings
used for domestic purposes.
EN – ENGLISH