KidKraft Cedar Summit Timber Trail Playhouse Installation And Operating Instructions Manual page 34

Step 11: Attach Bench Assembly
Part 1
A: Place 2 (111) Chair Bottoms across the assembly so they are resting on the (102) Chair Support and the
(101) Counter Post Bottom. (fig. 11.1, 11.2, 11.3)
B: Make sure that the (111) Chair Bottoms are flush to the ends of (102) Chair Support as shown in figure 11.2
and that there is a measurement of 11-5/32" between the (111) Chair Bottoms on the opposite end as shown in
figure 11.3.
C: Attach (111) Chair Bottoms to the (102) Chair Support and (101) Counter Post Bottom using 4 Narrow Angle
Brackets with 2 (S0) #8 x 7/8" Truss Screw per bracket. (fig. 11.1, 11.2, 11.3)
Fig. 11.2
Flush
111
102
Wood Parts
2 x Chair Bottom 1" x 2" x 45 15/16"
111
Narrow
Angle
Bracket
x 2 per
S0
bracket
111
Flush
8 x
Fig. 11.1
111
Fig. 11.3
Flush
maintain a gap of 28.3cm (11-5/32") between bench rails
111
Hardware
#8 x 7/8" Truss Screw
S0
34
11-5/32"
(283mm)
S0
101
x 2
S0
maintain a gap of 28.3cm (11-5/32") betwe
Narrow
Angle
Bracket
Other Parts
4 x Narrow Angle Bracket
Flush
x 2
111