KidKraft Cedar Summit Timber Trail Playhouse Installation And Operating Instructions Manual page 33

Step 10: Attach Bench Support
Part 2
B: From the inside of (021) Panel Assembly, place (102) Chair Support against the back section of the inner Side
Wall making sure there is a measurement of 12-3/8" from the bottom of the panel to the top of the board. Check to
make sure the board is level, then attach using 4 (S15) #8 x 1-3/4" Wood Screws. (fig. 10.4, 10.5, 10.6)
Fig. 10.5
Wood Parts
1 x Chair Support 1" x 2" x 13 1/8"
102
Fig. 10.4
31.4cm/12-3/8"
from ground to top of both bench supports
12-3/8"
(314mm)
Fig. 10.6
31.4cm/12-3/8"
from ground to top of both bench supports
Hardware
4 x #8 x 1-3/4" Wood Screw
S15
102
021
S15
33
x 4