Table of Contents
Advertisement
Manual Leveler
1. Using the manual leveler, screw the leveler tube onto
the leveler screw assembly (See Figure 3-3.) Initially
leave approximately 3" of threads visible, further
adjustment may be required. Rotate the tube so that
the zerk hole in the threaded end is pointing upward.
ASSEMBLY INSTRUCTIONS
2. Install the manual leveler handle assembly into the
front end of the leveler tube and fasten with two
5/8-11 x 3-1/2 hex head cap screws and hex lock
nuts. Insert a plastic wear flange bearing into the flat
side of each leveler cross bracket. Slide the brackets
over each side of the manual leveler cross and
secure with washers and 5/16" x 2-1/2" spring slotted
pins.
3. Attach the leveler cross brackets to the top of the
leveler L link using 3/4-10 x 3-1/2 hex head cap
screws and hex lock nuts.
4. Install a grease zerk in the threaded end of the
leveler tube.
3-7
Hide quick links:
Advertisement
Table of Contents
