Toyota Highlander Hybrid 2020 Owner's Manual page 91

• When the outside temperature
has changed suddenly (at the
entrance/exit of a garage, tunnel,
etc.)
● When "--" or "E" is displayed, the
system may be malfunctioning.
Take your vehicle to your Toyota
dealer.
■ Liquid crystal display
Small spots or light spots may
appear on the display. This phenom-
enon is characteristic of liquid crys-
tal displays, and there is no problem
continuing to use the display.
■ Customization
The meters can be customized on
of the multi-information display.
(P.100, 110)
WARNING
■ The information display at
low temperatures
Allow the interior of the vehicle to
warm up before using the liquid
crystal information display. At
extremely low temperatures, the
information display monitor may
respond slowly, and display
changes may be delayed.
For example, there is a lag
between the driver's shifting and
the new gear number appearing
on the display. This lag could
cause the driver to downshift
again, causing rapid and exces-
sive engine braking and possibly
an accident resulting in death or
injury.
NOTICE
■ To prevent damage to the
engine and its components
● Do not let the indicator needle
of the tachometer enter the red
zone, which indicates the maxi-
mum engine speed.
HIGHLANDER HV_U
2-1. Instrument cluster
● The engine may be overheating
if the engine coolant tempera-
ture gauge is in the red zone
(H). In this case, immediately
stop the vehicle in a safe place,
and check the engine after it
has cooled completely.
(P.497)
Odometer and trip meter
display
Display items
■
 Odometer
Displays the total distance the vehi-
cle has been driven.
 Trip meter A/trip meter B
Displays the distance the vehicle
has been driven since the meter
was last reset. Trip meters A and B
can be used to record and display
different distances independently.
Changing the display
■
Each time the "ODO TRIP"
switch is pressed, the displayed
item will be changed. When the
trip meter is displayed, pressing
and holding the switch will reset
the trip meter.
91
2