Toyota Highlander Hybrid 2020 Owner's Manual page 234

234
4-3. Operating the lights and wipers
■ Temporarily lowering sensor
sensitivity
The sensitivity of the sensor can be
temporarily lowered.
1
Turn the power switch off while
the following conditions are met.
● The headlight switch is in
.
● The headlight switch lever is in
high beam position.
● Automatic High Beam switch is
on.
2
Turn the power switch to ON.
3 Within 60 seconds after step 2,
repeat pulling the headlight
switch lever to the original posi-
tion then pushing it to the high
beam position quickly 10 times,
then leave the lever in high beam
position.
4
If the sensitivity is changed, the
Automatic High Beam indicator
is turn on and off 3 times.
Automatic High Beam (headlights)
may turn on even when the vehicle
is stopped.
Turning the high beams
on/off manually
Switching to the low beams
■
Pull the lever to its original posi-
tion.
The Automatic High Beam indicator
will turn off.
Push the lever away from you to
activate the Automatic High Beam
system again.
HIGHLANDER HV_U
or
Switching to the high
■
beams
Press the Automatic High Beam
switch.
The Automatic High Beam indicator
will turn off and the high beam indi-
cator will turn on.
Press the switch to activate the
Automatic High Beam system
again.