Toyota Highlander Hybrid 2020 Owner's Manual page 56

56
1-2. Child safety
2
Place the child restraint sys-
tem on the rear seat facing
the rear of the vehicle.
3
Run the seat belt through the
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
4
Fully extend the shoulder belt
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
5
While pushing the child
restraint system down into
HIGHLANDER HV_U
the rear seat, allow the shoul-
der belt to retract until the
child restraint system is
securely in place.
After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
6
After installing the child
restraint system, rock it back
and forth to ensure that it is
installed securely. (P.59)
Forward-facing  Convert-
■
ible seat
1
Adjust the seat
When using the front passen-

ger seat
If installing the child restraint
system to the front passenger
seat is unavoidable, refer to
P.53for the front passenger seat
adjustment.
When using the rear seat

If there is a gap between the
child seat and the seatback,
adjust the seatback angle until
good contact is achieved.