Table of Contents
Advertisement
Figure 76. Routing the power cord loop in the cable management arm
4. Disconnect the power cords from the system unit as shown in the following figure.
Note: This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the power to be off, then ensure that all the power sources to the system are
disconnected.
112 Power Systems: Installing the System and Ordered Parts for the IBM Power System IC922 (9183-22X)
Advertisement
Table of Contents
Need help?
Do you have a question about the Power System IC922 and is the answer not in the manual?
Questions and answers