Starting The N1091..Ca Series Ieee 802.3 Nrz Compliance Test Application - Keysight Technologies N1091 CA Series Getting Started

Starting the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application

After you install the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application on a PC (with or
without the N1010A FlexDCA interface) or on the N1000A or 86100D Oscilloscope, refer to the
following sections to start the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application:
•
•
•
IEEE 802.3 NRZ Compliance Test Application Getting Started
If the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application and the N1010A FlexDCA
Software are installed on the same PC and the DCA-X or DCA-M Oscilloscope is being accessed
remotely, see "Starting the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application"
page 50.
If the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application is installed on a PC (but the
N1010A FlexDCA Software is not installed) and the DCA-X or DCA-M Oscilloscope is being
accessed remotely, see "Starting the N1091..CA Series IEEE 802.3 NRZ Compliance Test
Application" on page 75.
If the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application is installed on the N1000A
or 86100D Oscilloscope, see
Application" on page 92.
"Starting the IEEE 802.3 NRZ Test App-Series Compliance Test
Introduction 1
on
19