Table of Contents
Advertisement
3
Installing N1091..CA on a PC Without N1010A FlexDCA
Connecting the Equipment
1
Table 5
Installed Module Configurations
86108A/B
N1060A
86112A, 54754A, 86117A, or 86118A-H01
86107A (any option)
N4877A, N1076 A/B, N1077A, N1078A Clock Data
*
Recovery Options 216/232
N1045A, N1045B, and N1055A, N1046A 75/85/100
GHz
* If you have access to the clock for the device, you can connect the clock to the 86100D's or N1000A Trigger input instead of using the CDR.
2
Table 6
Configurations for DCA-M
N1094A
N1094B
N1092 C/E
3
60
For a DCA-X oscilloscope, install one of the module combinations listed in
86100D or N1000A.
Module combinations for DCA-X Oscilloscope
Single Plug-In Module
Setup
Available
For a DCA-M oscilloscope, keep in mind the information in the following table.
Supported configurations for DCA-M Oscilloscope
Requires N107x
√
√
√
Connect the equipment as shown in the connection diagrams above and power on all of the
instruments.
Multiple Plug-In
Module Setup
Available
(N107xA-232)
(N107xA-232)
(N107xA-232)
IEEE 802.3 NRZ Compliance Test Application Getting Started
Table 5
into the
Description
The 86108B can have either options LBW or
HBW plus 216 or 232.
Option 216 provides a maximum data rate of 16
Gb/s. Option 232 provides a maximum data rate
of 32 Gb/s.
Advertisement
Table of Contents
