Table of Contents
Advertisement
Connecting to the N4877A
The N4877A is used whenever multiple N1000A or 86100D modules are used in the test setup rather
than an 86108A/B module. Refer to
N OTE
On the 86100D, click Setup > Configure Extended Modules. In the dialog box, perform the following two
steps:
1
2
For more information, click the Help button that is in the title bar of the Extended Module
Configuration dialog box.
Figure 53
IEEE 802.3 NRZ Compliance Test Application Getting Started
This section lists the steps for 86100D DCA-X oscilloscope. Perform similar steps for the
N1000A DCA-X oscilloscope.
Configure Slot 8 to be the N4877A.
Remove any other N4877A that is configured for Slot 5, Slot 6, or Slot 7.
The Extended Module Configuration with the N4877A in Slot 8
Installing N1091..CA and N1010A FlexDCA on a PC
Table 3
on page 34.
2
53
Advertisement
Table of Contents
