Table of Contents
Advertisement
Connecting N1010A FlexDCA to N109X Oscilloscope and N107X
Perform the following steps to connect your N109X oscilloscope with N107X clock data recovery
using FlexDCA:
1
2
3
4
5
6
7
IEEE 802.3 NRZ Compliance Test Application Getting Started
Launch FlexDCA.
When FlexDCA starts, the Extended Module Configuration window is displayed automatically. If the
Extended Module Configuration window does not appear, from the FlexDCA interface's main menu,
click Setup>Configure Extended Modules....
Configure Slot 7 to be the N109X module.
Configure Slot 8 to be the N107X module.
Remove any other N109X/N107X that is configured for Slot 5 and Slot 6.
Click Close to exit the Extended Module Configuration window.
Once the connection is established, you may proceed to launch the N1091..CA Series IEEE 802.3
NRZ Compliance Test Application on your PC.
Installing N1091..CA and N1010A FlexDCA on a PC
2
49
Advertisement
Table of Contents
