Huawei UPS5000-A User Manual page 115

UPS5000-A-(60 kVA-120 kVA)-H
User Manual
Input Setting
Issue 05 (2020-01-10)
Item Description
mode. When the D.G. is
connected to the dry contact
signal GEN:

If this parameter is set to
Enable, the system can enter
ECO bypass mode when the
D.G. supplies power to the
bypass and the ECO function
is enabled.
 If this parameter is set to
Disable, the system is not
allowed to enter ECO mode
when the D.G. supplies power
to the bypass.
RAM Enable or disable the memory
verification check function. If this parameter
is set to Enable, the control chip
RAM working status is checked
regularly. If this parameter is set
to Disable, regular check is
disabled.
Collect real- If this parameter is set to Enable,
time site one waveform can be stored
waveform manually.
BCB trips in If this parameter is set to Enable,
case of EOD
the BCB will trip in case of
EOD.
Item Description
D.G. mode Set this parameter to Enable
when a D.G. connects to the
input PDC. The UPS enters the
D.G. mode when a D.G. is
detected over dry contacts.
D.G. power Set these two parameters to
limiting (kVA)
control the valid input current
and limiting input current, which
D.G. charger
prevents load impact and
power ratio (%)
facilitates better cooperation
between the UPS and the D.G.
Input cur. Specifies whether to enable or
limiting
disable input current limiting to
protect generators.
Copyright © Huawei Technologies Co., Ltd.
4 LCD and WebUI
Default Value Value Range
Disable Disable, Enable
Disable Disable, Enable
Enable Disable, Enable
Default Value Value Range
Disable Disable, Enable
Depends on the 0 kVA to 5000
actual model. kVA
0 0%–100%
Disable Disable, Enable
107