Full Flue Liner - (Required In Canada) - Pacific energy Alderlea T5 LE Insert Installation And Operating Instructions Manual

Full Flue Liner - (Required in Canada)

In Canada, this Fireplace Insert must be installed with a continuous chimney liner extending from the Fireplace
Insert's Flue Collar to the top of the chimney. The chimney liner must conform to the class 3 requirements of
CAN/ULC-B365, Standard for Lining Systems for Existing Masonry or Factory-Built Chimneys and Vents, or
CAN/ULC-S640, Standard for Lining Systems for New Masonry Chimneys.
1. Measure the chimney height from the top of the existing Chimney flue to the floor of the hearth. This will
allow extra length of liner for flashing and rain cap.
2. Feed the stainless steel liner from top of the chimney, through the damper area and into the fireplace cav-
ity. Attach a "stove to liner" adapter to the bottom of the liner as per the liner manufacturer's instructions.
3. The Flue Collar is packaged in the stove. Attach
the Flue Collar to the liner adapter and secure
with three Stainless screws. Caulk around
connections with high temp stove cement.
Ensure the gasket is in good working shape.
4. Remove the Cast Top by lifting up on the front
and pulling toward you. Remove both the right
& left Blower Covers; Lift up and pull the covers
towards you to release the tabs.
5. Remove the Baffle.
6. Push unit into the fireplace. Use the front or rear
adjustment legs, level the insert depending on
your hearth configuration. (NOTE: Adjustment
legs are located in the bottom, front and rear of
the insert).
7. Reach through the flue opening and pull down
on the Flue Collar with the tool provided until the
bolts pass through the mounting holes in the flue
opening. Install the clamps and nuts. center the
collar on the opening and tighten the nuts.
8. Measure, trim and shape a Chimney top flashing
to fit the existing chimney flue. Plan for a 1" to
1-1/2" overlap on each side. Place flashing over
top of the liner and seat firmly against the flue
tile.
9. Attach a rain cap to the end of the liner. A storm
collar may be used if desired.
10. Install the surround See "Surround Assembly
and Installation" on page 20, Re-Install the
top and Blower covers in the reverse order they
were removed.
100003038
Rain Cap
Stainless Steel
Chimney Flashing
Stainless Steel
Rigid or Flex Liner
Full Flue Liner
Flex Liner
Connector
Figure 6: Insert LE full flue liner.
16
ALT5 LE Insert 230819-32