Operation - ADJ NINJA 5RX User Instructions

Ninja 5RX
Tilt 4 Offset
- Adjustment of mirror 4 home position.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that "Tilt 4" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Color
- Adjustment of the color wheel.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that "Color" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Gobo
- Adjustment of the gobo wheel.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that "Gobo" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Roll
- Adjustment of the center cone mirror.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that "Roll" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
Strobe
- Adjustment of the strobe.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that "Strobe" is displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 18
Offset Menu Ninja 5RX
Universal DMX Control:
sal DMX-512 controller. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Ninja 5RX has 3 DMX channel modes; 1 channel mode, 10
channel mode, a 13 channel mode. To set the channel mode
see page 10. See pages 22-28 a for detailed description of the
DMX traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-7 as well as the set-up specifications that are
included with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 10 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode:
units linked together, to run to the beat of the music.
1. Press the MENU button until "Sound State" is displayed, and
press ENTER. Press the UP or DOWN buttons so that "ON" is dis-
played and press ENTER.
2. Press the MENU button until "Sound Sense" is displayed, and
press ENTER. Use the UP and DOWN buttons to adjust the sound
sensitivity. Press ENTER when you have found your desired sensi-
tivity level.
Show Mode:
together, to run 1 of 12 light shows. Show mode can be run with sound
active mode on or off.
1. Press the MENU button until
press ENTER.
2.
Press the UP or DOWN buttons until you find your desired show,
and press ENTER to confirm.
This function allows you to use a univer-
This mode allows either single unit or several
This mode allows a single unit or several units linked
"Show Mode" is displayed, and
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 19

Operation