ADJ NINJA 5RX User Instructions page 6

Ninja 5RX
System Menu: When making adjustments press eNTeR to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
DMX Address
- Set the DMX Address -
1. Press the MENU button until "DMX Addresss" is displayed,
press ENTER.
2. "X" will now be displayed, "X" represents the displayed
address. Press the UP or DOWN buttons to find your desired
address.
3. Press ENTER to confirm, and then press and hold the MENU
button for at least three seconds to assign.
Channel Mode
- This will let you select your desired
DMX Channel mode.
1. Press the MENU button until "Channel Mode" is displayed,
press ENTER.
2. "X Chan" will now be displayed, "X" represents the displayed
DMX channel mode. Press the UP or DOWN buttons to find your
desired Channel mode.
3. Press ENTER to confirm.
Slave Mode -
This will let you set unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until "Slave Mode" is displayed,
press ENTER. Either "Master", "Slave 1" or "Slave 2" will be
displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, then press ENTER to confim.
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 10
Ninja 5RX
System Menu
NOTe: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to "Slave 2", the
fixtures will now have contrast movement to each other.
Show Mode
1. Press the MENU button until "Show Mode" is displayed, press
ENTER.
2. "Show X" will now be displayed, "X" representing a number
between 0-12. Shows 1-12 are preset shows, while "Show 0" will
run random shows. Press the UP or DOWN buttons to find your
desired show and press ENTER to select your show.
Sound State
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
- Show modes 0 - 12 (Preset Shows).
- In this mode the unit will run in sound
- In this mode you can adjust the sound
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 11
System Menu