Page 2
Products, LLC brands and product names are trademarks or registered trademarks of their respective companies. ADJ Products, LLC and all affiliated companies hereby disclaim any and all liabilities for property, equipment, building, and electrical damages, injuries to any persons, and direct or indirect economic...
Stinger General Information Unpacking: Thank you for purchasing the Stinger by ADJ Products, LLC. Every Stinger has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all equipment necessary to operate the unit has arrived intact.
Page 4
During operation the housing may become extremely hot. Avoid touching the unit with bare hands while in use. ADJ Products, LLC will not accept any liability for any resulting damages caused by the non-obser- vance of this manual or any unauthorized modification to this unit.
B. Objects have fallen, or liquid has been spilled into, the unit. C. The unit has been exposed to rain or water. D. The unit does not appear to operate normally or exhibits a marked change in performance. ADJ Products, LLC - www.adj.com - Stinger User Manual Page 5...
The legal requirements for using laser entertainment products vary from country to country. The user is responsible for determining the legal requirements at the location/country of use. Always use proper lighting safety cables when hanging lights and effects overhead. ADJ Products, LLC - www.adj.com - Stinger User Manual Page 6...
Stinger DMX Set Up Power Supply: The ADJ Stinger contains an automatic voltage switch, which will auto sense the voltage when it is plugged into the power source. With this switch there is no need to worry about the correct power voltage, this unit can be plugged in anywhere.
Page 8
XLR connector of the last unit in your daisy chain to terminate the line. Using a cable terminator (ADJ part number Z-DMX/T) will decrease the chances of erratic behavior. 5-Pin XLR DMX Connectors. This unit use 5-pin DMX-512 data cables for DATA transmission. 5-pin DMX fixtures may be implemented in a 3-pin DMX line.
The equipment must be installed by a professional, and it must be installed in a place where it is out of the reach of people’s grasp. Stinger Laser Warning Labels ADJ Products, LLC - www.adj.com - Stinger User Manual Page 9...
Sh_7: LED + Strobe + Laser mixed show Sens 0-99 sound sensitivity from low to high ON: Sound mode ON, run Sound mode Soun OFF: Sound mode OFF, run auto mode Vers Ve1.4 software version ADJ Products, LLC - www.adj.com - Stinger User Manual Page 10...
Page 11
VER - Use this function to display the Software version of the unit. 1. Press the either the MENU button until “VER” is displayed, press ENTER. 2. The display will show the software version. ADJ Products, LLC - www.adj.com - Stinger User Manual Page 11...
1. Press the MENU button until “Show” is displayed, and press ENTER. 2. Press the UP or DOWN buttons to find your desired show and press ENTER. The unit will now run your chosen built-in program. ADJ Products, LLC - www.adj.com - Stinger User Manual Page 12...
Low frequencies (bass) should cause the unit to react to sound. Tapping on the microphone or other quiet or high pitched sounds may not activate the unit. • Check the sound sensitivity level, and adjust if necessary. ADJ Products, LLC - www.adj.com - Stinger User Manual Page 16...
Need help?
Do you have a question about the Startec STINGER and is the answer not in the manual?
Questions and answers