Dmx State - ADJ NINJA 5RX User Instructions

Ninja 5RX

DMX State

- This mode can be used as a precaution
mode, that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until "DMX State" is displayed, press
ENTER.
2. Either "Master/Slave" or "Blackout", or "Last State" will be
displayed. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal is lost or power is applied, the
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Back Light
- With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until "Back Light" is displayed, press
ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or
DOWN buttons to select "ON" to keep the backlight on at all
times, or "OFF" to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 12
System Menu Ninja 5RX
Tilt 1 Inverse
1. Press the MENU button until "Tilt 1 Inverse" is displayed,
press ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select "Normal" and press Enter.
Tilt 2 Inverse
1. Press the MENU button until "Tilt 2 Inverse" is displayed,
press ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select "Normal" and press Enter.
Tilt 3 Inverse
1. Press the MENU button until "Tilt 3 Inverse" is displayed,
press ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select "Normal" and press Enter.
Tilt 4 Inverse
1. Press the MENU button until "Tilt 4 Inverse" is displayed,
press ENTER. Either "Normal" or "Inverse" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Inverse" is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select "Normal" and press Enter.
- Tilt Inversion (Top Mirror)
- Tilt Inversion (Right Side Mirror)
- Tilt Inversion (Bottom Mirror)
- Tilt Inversion (Left Side Mirror)
ADJ Products - www.adj.com - Ninja 5RX Instruction Manual Page 13
System Menu