Nortel 1000E Upgrade page 93

Figure 22
Upgrade boot sequence
Communication Server 1000E Upgrade
3 Support for rev. M Simpletech compact flash cards is included.
Use Procedure 10 to install the CP PM software.
Procedure 10
CP PM Software installation
1 Connect the terminal to port 0 with the NTAK19EC cable.
2 Insert the RMD into the Call Server faceplate.
3 Reboot the card. When prompted (see Figure 22), enter F to "force board
to boot from faceplate drive" (prompt may appear twice).
The VxWorks banner screen appears (see Figure 23 on
Installing the software
End of Procedure
Option 11C Chassis to Communication Server 1000E
Page 93 of 228
page 95):