Nortel 1000E Upgrade page 183

Figure 103
Leader/Follower Signaling Server configuration
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Note: This step will over-write all existing configuration parameters
on this Signaling Server.
Please select the role of this Signaling Server.
If this Signaling Server will be a Leader then its data networking
and IP Telephony parameters must be entered now. (This will pre-
configure the IP Telephony node files.)
If this Signaling Server will be a Follower then its data networking
and IP Telephony parameters must be configured through Element
Manager later.
Please enter:
<CR> -> <a> - Set this Signaling Server as a Leader.
<b> - Set this Signaling Server as a Follower.
<q> - Quit.
Enter Choice>
Communication Server 1000E Upgrade
4 Enter the location (loop and shelf) of the IPMG board.
Note: If the IPMG has not been configured yet, the loop and shelf
information can be left at the current value. The IPMG board location can
be updated using OAM shell commands after the Signaling Server is
configured.
5 The Leader/Follower configuration screen appears (Figure 103).
6 Configure the Signaling Server as a Leader or Follower. If there is already
a Leader Signaling Server in the IP Telephony node, enter b at the prompt
to configure this Signaling Server as Follower. The Follower Signaling
Server configuration screen appears (Figure 104). Go to step 15 on
page 175.
Installing a Signaling Server
Option 11C Chassis to Communication Server 1000E
Page 183 of 228