433Mhz Wireless Channel Change - Inateck P7 User Manual

2.1.1 433MHz Wireless Channel Change

There are 6 channels available when the P7 is in the 433MHz wireless mode, and the default is
"channel 0". If you want to use multiple P7 scanners in the same place, it is suggested to set
every barcode scanner to different channels so as to avoid wireless signal interference.
Steps to set the working channel to "channel 1": Firstly, make sure the USB adapter is within the
connection range. Then read the barcode "Enter setup, "Set 433MHz channel", "Channel 1" to set
the channel. P7 will exit the setting status automatically after the successful setting.
Note: Switching channel only works for the paired USB dongles. If a P7 is paired with multiple
USB dongles, you can plug all the paired dongles into computers and set it once, and all the
dongles could switch channels.
Set 433MHz channel
Channel 1
Channel 3
Channel 5
（*）Channel 0
27
Channel 2
Channel 4
Enter setup