E.g.: To set the scanning mode to Red Light Auto-off mode and set the Red Light auto-off waiting
time to 1s, you need to:
1. Read the "Enter Setup" barcode;
2. Read the "Red Light Auto-off Mode" barcode;
3. Read the "Setup Auto laser-off waiting time" barcode;
4. Read the "1s" barcode;
5. Read the "Exit with Save" barcode.
1.6.2 Continuous Scanning Mode
There's no need to press the scanning trigger in this mode, As the red light of the scanner will be
on and the scanner will enter into scanning mode automatically.
The red light of the scanner will not go off until Inateck P7 scans a barcode. And the laser will go
off once the scanner scans barcode successfully. And then the scanner will go into waiting mode,
in which the waiting time (also known as intermittent time of continuous scanning), usually
defaults to 2 seconds, and can be set to 400ms, 800ms,1s,2s,3s,5s, 10s and 15s.
The red light of the scanner will be on again once the waiting time is over. It will only go off when
the scanner scans a barcode successfully. And it will go back and forth like this.
Continuous Scanning Mode
Setup Intermittent time of Continuous scanning
400ms
800ms
1s
(*)2s
19