3.4 Code 39
3.4.1 Enable/Disable Code 39
Decide whether to enable Code 39. Inateck P7 Scanner defaults "Enable Code 39"
.
(*)Enable Code 39
Disable Code 39
3.4.2 Start/Stop Transmission
Decide whether to transmit the Start/Stop characters. Inateck P7 takes disabling transmitting
Code39 Start/ Stop Characters as default.
Transmit Code 39 Start/Stop Characters
(*)Do Not Transmit Code 39 Start/Stop Characters
Steps to enable code 39 but not transmit code 39 Start/Stop Characters are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 39" barcode; (If Code 39 is disabled, it is needed to enable it);
3. Read the "Do Not Transmit Code 39 Start/Stop Characters" barcode;
4. Read the "Exit with Save" barcode.
Enter setup
Exit with save
39