Connection; Wireless Adapter Mode - Inateck BCST-54 Instruction Manual

Enter Setup

Connection

Wireless Adapter Mode

Wireless Adapter Mode is the default connection mode. To use this mode please refer to the
details below.
1. Power on Inateck BCST-54 by toggling switch from OFF to ON
2. Plug the USB adapter into a computer. If the indicator light flashes once, it means the
connection is successfully built. Short press the trigger on the barcode scanner and it will
emit red light beam, and then the barcode scanner can work under Wireless Adapter Mode.
3. Open a file on the computer and move cursor to the place where scanning result should
be displayed and saved.
Note:
1) Wireless Adapter Mode is the default connection mode of BCST-54 barcode scanner. If
you are using Bluetooth connection mode and want to switch it back to the Wireless
Adapter Mode, please scan the setting barcodes in sequence "Enter Setup" - "Wireless
Adapter Mode" - "Exit with Save".
(*)Wireless Adapter Mode
Exit and Save
18