Iata 2 Of 5; Enable/ Disable Iata 25; Checksum Verification - Inateck P7 User Manual

3.11 IATA 2 of 5

3.11.1 Enable/ Disable IATA 25

Decide whether to enable IATA 25 by scanning correspondent barcode below. Inateck P7 defaults
"Disable IATA 25".
Enable IATA 25
（*）Disable IATA 25

3.11.2 Checksum Verification

Checksum character is not enforced to be included in the IATA 25 data. If checksum character is
included, it should be the last character of the barcode data. As a calculate value bases on all the
data, Checksum character is used to check if the data is correct or not.
Thus, if the scanner is set to "Do Not Verify IATA 25", which is default, then the scanner will read
and output all the IATA 25 barcodes.
If the scanner is set to "Verify IATA 25 with Output Checksum Character", and the scanner will
check the data based on the last character of the barcode data. If the check passes, Inateck P7
will read and output the Checksum Character as the last character of normal data. However, it
will not be able to read IATA 25 without checksum character.
If the scanner is set to "Verify IATA 25 without Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check passes, Inateck
P7 will read but will NOT output the Checksum Character as the last character of normal data.
However, it will not be able to read IATA 25 without checksum character.
（*）Do Not Verify IATA 25
Verify IATA 25 with Output Checksum Character
53