Standard 2 Of 5 / Industrial 2 Of 5; Enable / Disable Standard 25; Checksum Verification - Inateck P7 User Manual

3.14 Standard 2 of 5 / Industrial 2 of 5

Standard 2 of 5 is also known as Industrial 2 of 5.

3.14.1 Enable / Disable Standard 25

Decide whether to enable Standard 25 by scanning correspondent barcode below. Inateck P7
defaults to "Disable Standard 25".
Enable Standard 25
（*）Disable Standard 25

3.14.2 Checksum Verification

Checksum character is not enforced to be included in the data of Standard 25. If checksum
character is included, it should be the last character of the barcode data. As a calculate value
based on all the data, Checksum character is used to check whether the data is correct or not.
If the scanner is set to "Do Not Verify Standard 25", which is the default, then the scanner will
read all the barcode data.
If the scanner is set to "Verify Standard 25 with Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check passes, the
scanner will read and output the Checksum Character as the last character of normal data.
However, the scanner will not be able to read Standard 25 without checksum character under
this setting.
If the scanner is set to "Verify Standard 25 without Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check passes, the
scanner will read but will NOT output the Checksum Character. However the scanner will not be
able to read Standard 25 without checksum character under this setting.
（*）Do Not Verify Standard 25
56