Vibration Notification - Inateck P7 User Manual

For example: Steps to set Minimum Volume for beeper are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Minimum Volume" barcode;
3. Read the "Exit with Save" barcode.
Note: The factory default value for each setting is marked by an asterisk "*".
Enter setup
Exit without save

1.5 Vibration Notification

The P7 barcode scanner is featured with vibration notification which is turned on by default, to
indicate successful scanning. You can enable/disable this function and adjust the vibration
strength.
Turn off the vibration notification
Turn on the vibration notification (strong)
The steps to turn off the vibration notification are as follows:
1） Read "Enter setup" barcode.
2） Read "Turn off the vibration notification" barcode.
3） Read "Enter with save" barcode.
Enter setup
（*）Turn on the vibration notification (weak)
17
Exit with save