Section
Lifting Two Headers, page 15
2.4 Lowering Header, page 16
• Step
6, page 19
3.1.4 Attaching Center Support –
Double Reel, page 35
• Step
1, page 35
3.1.6 Attaching Cam Arms, page
37
• Step
5, page 38
3.1.6 Attaching Cam Arms, page
37
• Step
6, page 38
3.1.6 Attaching Cam Arms, page
37
• Figure
3.47, page 39
3.1.6 Attaching Cam Arms, page
37
• Step
3.2.6 Assembling Draper, page
54
Installing Right Reel, page 82
• Step
18, page 85
3.3.5 Installing Deck, page 97
• Step
14, page 100
3.2.6 Assembling Draper, page
54
215184
Summary of Change
inadequate equipment may result in vehicle tipping, machine
damage, or chain breakage.
Changed the following IMPORTANT to a WARNING for
consistency:
• Equipment used for loading and unloading must meet or
exceed the minimum specified requirements. Using
inadequate equipment may result in vehicle tipping, machine
damage, or chain breakage.
Added pictures to identify the center-link anchor on single and
double-reel headers.
Added the following to the step:
• Retain for reinstallation.
Changed the picture to make the step generic to five, six, and
nine-bat reels.
Added the IMPORTANT to emphasize the correct installation of
the shim.
Added picture of nine-bat reel for additional reference.
Added step.
Removed the following WARNING ONLY because the header is
considered to be inoperative and not fully assembled at this point
in the manual:
• To avoid bodily injury or death from unexpected start-up or
fall of raised machine, always stop engine, remove key, and
engage safety props before going under machine for any
reason.
Corrected reference to next step in manual.
Reworded step as follows to be consistent with
• Adjust deck height to obtain clearance (A) of 7–11 mm
(1/8–7/16 in.) between top of deck and inside cutterbar
(i.e., the thickness of the draper plus 3 mm).
Removed the following WARNING ONLY because the header is
considered to be inoperative and not fully assembled at this point
in the manual:
iii
Internal Use
Tech Pubs
Product Support
Tech Pubs
Tech Pubs
Product Support
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
12, page
53.
Tech Pubs
Tech Pubs
Only
Revision A
Need help?
Do you have a question about the D1 Series and is the answer not in the manual?