MacDon D1 Series Unloading And Assembly Instructions page 10

Section
• Step
3, page 209
7.1.1 Attaching Header to an
AGCO (Challenger, Gleaner, or
Massey Ferguson) Combine, page
205
• Table
7.2, page 207
™
7.2 AGCO IDEAL Series
Combines, page 213
7.2.1 Attaching Header to an
™
AGCO IDEAL Series Combine,
page 213
7.2.2 Installing Reel Fore-Aft /
Header Tilt Selector Switch, page
216
7.3.1 Attaching Header to Case
IH Combine, page 218
• Step
1, page 218
7.4.1 Attaching Header to CLAAS
Combine, page 224
• Step
1, page 224
7.5.1 Attaching Header to John
Deere Combine, page 229
• Step
1, page 229
7.5.2 Installing Reel Fore-Aft /
Header Tilt Switch – S and
T Series Combines, page 232
7.5.2 Installing Reel Fore-Aft /
Header Tilt Switch – S and
T Series Combines, page 232
• Step
1, page 232
7.5.3 Installing Reel Fore-Aft /
Header Tilt Switch – 60 and 70
Series Combines, page 239
7.5.3 Installing Reel Fore-Aft /
Header Tilt Switch – 60 and 70
Series Combines, page 239
• Step
1, page 239
215184
Summary of Change
• If you do not disconnect the battery before connecting the
cab draper control harness to the combine's auxiliary power
connectors, electrical components may be damaged.
Added "AGCO" to the kit number column.
™
Added AGCO IDEAL topics
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Added safety step:
• Shut down the engine, and remove the key from the ignition.
Replaced the DANGER with the following WARNING to be
consistent with similar procedures:
• To avoid injury or death from unexpected start-up of
machine, always stop the engine and remove the key from
the ignition before leaving the operator's seat for any reason.
Revised step to mean tilting the feeder house, not the header, all
the way forward.
Replaced the DANGER with the following WARNING to be
consistent with similar procedures:
• To avoid injury or death from unexpected start-up of
machine, always stop the engine and remove the key from
the ignition before leaving the operator's seat for any reason.
Added safety steps and revised IMPORTANT to be consistent with
similar procedures.
• Procedure now says to disconnect the battery negative cable,
not the positive cable.
viii
Internal Use
Only
Tech Pubs
ECN 57194
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Product Support
Tech Pubs
Tech Pubs
Revision A